
Taking a closer look, the frame is usually made out of plated, metal tubing, supported at a variety of different contact points throughout the craft. Following a basic flow for strength and support, and depending on the manufacturer, the craft has one (or two) wheels in front, followed by two bars that stick out in front (for steering with your feet), an instrument panel with gauges and such, a seat, (or two, if it is a two-seater) two controls for ground steering and engine speed, a gas tank, and an engine with a two, three or four blade propeller. Around the propeller, there are round prop rings to protect people from walking into the prop and to protect the prop from other things bouncing into it.
Just behind the center line of the craft, are attach points, near the top, that are connected to the parachute, through lines called risers and then to the actual lines that hook to the parachute. When not used, the parachute usually rests in a protective bag, sitting on the seat or strapped to one of the tubes, depending on the design of the bag.
Powered parachutes like calm air; you really don't want to go up went the wind is gusty or more than 15 MPH. Sometimes ( a lot of times!) Wisconsin weather does not cooperate and then die-hard PPC'ers talk the talk, or look at flying pictures or videos that they have taken or purchased. Yes, it gets this bad (cannot fly) sometimes! :(
When the wind is calm enough and you are in the right frame of mind to fly, the PPC is either trailered to a farmer's field or (if you are lucky) you can fly right from your back yard. The craft is then pre-flighted, which means to say that every screw, bolt, nut, and piece is gone over to make sure it's all tight, filled, pumped up, and ready to roll. Then, the engine is started and taken to a certain temperature to make sure there are no problems. In the meantime, you put up your windsock, or other wind-direction/speed device, check the batteries in the radio, get your helmet out and dress for the day's temperature.
Once the engine is warmed up, the PPC is un-strapped and unloaded from the trailer and pushed or driven to a place for take-off. It is always pointed into the wind! The chute bag is then place behind the craft, just like it was in the seat (do not turn!), dumped out on the ground, and placed in an arc on the ground.
Putting your helmet on, you do another check of the lines and risers, make sure your radio is working, the strap yourself in the seat.